Впишете се, за да последвате темата
Последователи
0
Как да преброим частите в колекцията си
От
maniak, в LEGO софтуер - LDD, Stud.IO и др.
-
Подобни теми
-
От legohead
Информацията от тази тема е взета от източник:
https://amodularlife.wordpress.com/2010/06/12/modular-standards-for-lego-city-buildings/
1. Straight buildings
Generally speaking, every baseplate is 32 studs deep. The width is variable with straight buildings, always being a multiple of 8 studs. A common used width is 16 studs wide. The connection points, pavement, walls etc. will then have the following sizes:
Whether your building is 8 studs wide or 64 studs wide, the sizes in depth are always the same. That way the Technic bricks with hole will always align and allow for the buildings to be attached to one another through the use of Technic pins.
2. Corner buildings
In the case of a corner building, you’re dealing with two connecting points at a 90 degree angle of each other. Therefore, your baseplate will always have to be 32 x 32 studs. Of course you can make the full building larger by attaching straight buildings forming a continuous whole at either side, but the corner module must be 32 x 32:
3. Variation in depth sizes
If you look at a real-life (old) street, you will see that not all buildings align in a perfectly straight line: some jut out a bit, others fall a little further back. If you put a number of CCMS buildings in a row, this method of alignment will give you the best result. As long as you leave the Technic bricks in the right position for connecting, you’re free to place your front and back wall at will. This might result in something like this:
Keep the variation in mind, because of your side wall. In some cases, part of your side wall will be visible. So if you were planning to omit your side wall, or make one out of all the colors you won’t be needing for the front and back walls, make sure that at least the edge of the side wall that juts out is made of a color that fits with the rest of the building.
I myself always build an entire side wall if I know the building is going to end up in a combined layout with other builders: because you don’t quite know what will end up next to you. For all you know you might end up next to a construction side, leaving your side wall entirely exposed.
4. Height
The last point I wish to address is height. In terms of height, you’re basically free to do whatever you want. Make it as tall or as low as you wish. One floor 6 bricks high, eight floors 12 bricks high each, everything is possible. Do keep in mind though, that if you’re making a very tall building, your side walls will definitely be visible. So make it into something exciting featuring windows or something, so it’s not just one boring, flat wall. Do take care that you won’t have anything protruding over the edges, since you may not know how high the building next to yours might be.
Variation in height is another reason to build side walls in a matching color when your creation will end up in a combined layout: the building next to yours might be very low and you won’t know ahead of time.
-
От Brickset
You wait ages for a new Technic pin to be introduced, then three come along at once!
What's interesting about them is that they have yet to be used in a Technic set.
Let's take a look at what they might be useful for.
Continue reading »
© 2021 Brickset.com. Republication prohibited without prior permission.
View the full article
-
От Illuminatus
Здравейте,
Наскоро се сдобих с един употребяван сет, където е необходимо да заменя няколко липсващи/повредени части:
Rubber Band Extra Small (Square Cross Section) – черен цвят, 6 броя Rubber Band Small (Square Cross Section) – черен цвят, 3 броя Technic, Axle and Pin Connector Perpendicular – стар тъмносив цвят, 1 брой Още не съм направил пълен преглед на инвентара, така че е възможно да се появят и други липси, но идеята ми е да разпитам тук на по-ранен етап, преди така или иначе да поръчам частите от Германия.
Мерси!
-
От legohead
Здравейте!
Нуждая се от бройки от следните части:
рамки 5x7 64179, сиво
https://brickset.com/parts/design-64179
Трябват ми количества 10-30 бр. Мога да ги закупя или да предложа размяна за за 64178
https://brickset.com/parts/design-64178
Също така ми трябват и няколко бройки плосък панел 64782 в цвят бяло
https://brickset.com/parts/6004135/flat-panel
Мога да ги закупя или да предложа размяна за черен цвят.
Ще ви бъда благодарен ако можете да ми съдействате.
Благодаря предварително!
p.s.
вече се сдобих с тези елементи
-
От DOSTIN
Здравейте в тази тема ще публикувам частите от които имам нужда за МОК-овете ми.
Wall Element 1X6X5 - Бял
https://brickset.com/parts/4504228/wall-element-1x6x5-abs
Wall Element 1X6X5 - светло син, прозрачен
https://brickset.com/parts/6245257/wall-element-1x6x5
Brick 1X2X5 - Светло син, прозрачен
https://brickset.com/parts/6251284/brick-1x2x5
Брик брикове, най-вече в светло и тъмно сиво
https://brickset.com/parts/design-98283
Прозорци най-вече тези в TAN цвят
6034929: Frame 1X2X3
https://brickset.com/parts/6034929/frame-1x2x3
Може и други цветове.
Относно количествата... всичко над 1 бройка е добре дошло.
-